![30 ppm in logger pro picture 30 ppm in logger pro picture](https://termometer.dk/wp-content/uploads/2021/03/thumb_sd800.jpg)
*6 Acquisition from a PC may not be possible in some PC environments. *5 Use is permitted only if the total power consumption of all measurement units, remote units, and environment-resistant measurement units used in the system is 50 W or less when remote units are not connected to an AC adapter. *4 Use is permitted only if the total power consumption of all connected measurement units is 20 W or less. The main unit’s automatic saving function allows data to be saved to an SD card in the main unit even if acquisition by PC stops. Using an onsite local network connection or wireless LAN connection may cause acquisition to stop due to a decrease in transfer speeds caused by network load or wireless LAN communication conditions. When acquiring data from a PC (using WAVE LOGGER X software), use a wired local connection only between the NR-X100W and the PC. *3 Wired LAN and wireless LAN cannot be used at the same time. Using a product not recommended by KEYENCE may result in data not being saved to the SD card during continuous acquisition. *2 Use only products recommended by KEYENCE (CA-SD4G: 4 GB, CA-SD16G: 16 GB). The available data buffer memory per NR-X100W and NR-XR01 group is limited to 25M. *1 Data is not backed up when the power is turned off.
![30 ppm in logger pro picture 30 ppm in logger pro picture](https://i.ebayimg.com/images/g/gJYAAOSwJZ5fy1Dq/s-l300.jpg)
External trigger input (TRG IN): Edge input.Insulation between input and system bus (500 VDC/1 minute).Maximum rating: 30 VDC, Minimum ON voltage: 10 VDC, Maximum OFF current: 0.2 mA.Input type: Bidirectional voltage input.For voltage input: ON voltage (Lo) 1.0 V or lower, OFF voltage (Hi) 2.4 V or more, Max.For non-voltage input: ON voltage 1.0 V or lower (short circuit current: 1 mA typ.), OFF current 0.1 mA or lower.Non-voltage (contact/non-contact)/voltage input, Falling edge input.Use as external trigger input (normal mode) or synchronous acquisition input (logging mode).±50 ppm (23☌ ☓☌ 73.4☏ ±5.4☏) Same time used for all remote groups, SNTP server time synchronization possible 500 kHz for all acquisition channels *6 *7īetween measurement units in the master data collection unit groupīetween the master data collection unit and each remote unit / environment-resistant measurement unit Unit expansion possible by connecting up to eight NR-XR01 remote units (connected by remote unit cable) Operation via NR-XCP30 control panel, or via WAVE LOGGER X with PC connectionĭedicated remote connection connector × 2 (Remote OUT A port, B port) RJ45 connector, 100Base-TX (AUTO MDI/MDIX supported) *3Ĭonnection via NR-XW1 wireless LAN unit, IEEE 802.11b/g/n *3įTP client function, FTP server function, SNTP client function
![30 ppm in logger pro picture 30 ppm in logger pro picture](https://agrowtek.com/images/virtuemart/product/resized/GCX_series_0x150.jpg)
USB mini-B connector, USB 2.0 High-speed–compliant, Simultaneous USB connection from one PC to up to four units (switchable by ID switch) Industrial Continuous Inkjet Printers / CIJ Printers.Laser Marking Systems / Continuous Inkjet Printers.LVDT / Contact Displacement Sensors (Probes).Spectral Interference Displacement Sensor.